well my issue isn't low end torque, it's high end RPMs......right now it's got a 62t spur gear and 12t CB that puts me around 5:2 priamry ratio...I'm also using 1/8 scale diffs putting me even lower for my final ratio than stock T-maxx gears.....when I ran my fantom .27 in it it was a monster....I had all th elow end torque adn loads of top from RPMs....well that engine is definately a throw away.....QC on them Sucks and I want something w/ buttloads of RPM.....it was a great combination of torque and speed.....as it sits now w/ the older mill it almost snatches the front off the ground.....and this thing is long (wheelbase) and runs a buggy drivetrain.....is torque the only reason you're swaying me from that route???
I am looking at the O.S. .30 for my basher MT though...looks like a sweet mill......

and any help on the RG conrod replacement would be appreciated as well
Thanks
Eric