PHOTO 1: Beginning of the fuselage alignment. Firewall and all formers (F2, F3, F4, F5 & F6) in place.
PHOTOS 2 & 3: FT-R (fuselage top rear) aligned in place above formers F3, F4, F5 and ending above F6. Rudder pushrod exit hole on the left side as instructed.
PHOTO 4: FB-R (fuselage bottom rear) aligned in place starting behind landing gear block and above formers F3, F4, F5 & F6 ending at rear of fuselage. FB-F (fuselage bottom front) aligned in place starting in front of landing gear block and above former F2 ending above firewall.
PHOTO 5: Former F7 aligned in place in front of former F3 and 1/8" below fuselage top sheeting (FT-R).
PHOTO 6: Tank floor aligned in place between firewall and former F2.
PHOTOS 7 & 8: Tail piece F8 in place between the fuselage sides at tail end behind former F6.
PHOTOS 9, 10 & 11: Various angles of completely aligned (and unglued) fuselage.