RCU Forums - View Single Post - Does anyone know of a source for a precut firewall?

11-01-2005 | 01:53 AM

#2

Marlowe

Member

My Feedback: (2)

Joined: Jan 2003

Posts: 40

Likes: 0

Received 0 Likes on 0 Posts

From: Penrose, CO

RE: Does anyone know of a source for a precut firewall?

Give Frank a call at
FX HOBBIES
501-984-5826
www.fxhobbies.com
[email protected]

He sells SPAD ARFs and he sells spare parts. I'm sure he would have what you need. Tell him Marlowe referred you to him. FYI I have many poly plastic firewalls using a jigsaw running at slow speed. If you run it at normal speed it will melt the plastic and make a mess, but slowed down with a speed controller you will throw chips rather than melt the plastic.

Reply Like