Well I finally got to fly it today, the VF x300 that is. The engine seemed to run ok. I took off and at about 50ft up the plane did a roll. I tried to get it level again and it rolled again. I pulled it up and it climbed but did another roll. I pulled the throttle back to idle and tried to loop back to my position but it just rolled and went in straight down. The planes a total loss. The receiver broke so I can't test it to see if it was the problem. I sure didn't have any control of it. The engine broke two fins just below the valve cover. Two spots about 3/16 long. That seems to be the only damage to it. All my digital servos seemed to have survived also.

Anyway,,, it wasn't the engine, it ran fine. Guess I'll keep it for now. Only bright spot this evening is that my G26 ran like a watch on my Jerry's Big Boy today,,, for a change. When it runs good, it's a joy to fly!