RCU Forums - View Single Post - Laying out foamwing cut outs
Thread: Laying out foamwing cut outs
View Single Post
Old 11-08-2002 | 09:52 PM
  #10  
patternwannabee
My Feedback: (1)
 
Joined: Oct 2002
Posts: 255
Likes: 0
Received 0 Likes on 0 Posts
From: Mars, PA
Default Laying out foamwing cut outs
For Servo boxes, I use the dremel with router attachment. This makes very smooth cuts.

For Servo wire tubes, I bore through the foam with a sharpened brass tube (1/2") using a jig to keep the channel straight.

Albert
patternwannabee is offline  
Reply Like