Looking for ideas now...
I've never had a plane where the on/off switch & voltometer were inside the canopy & not accessible from the outside!
So I'm sort of wondering how I'm going to do this & still make it "not a hassel" to get inside to turn the plane on & off.
Any ideas would be greatly appreciated!

I also found that putting that tape on the outside edge of the fuse,and then putting the canopy over it doesn't really work...
you can see the tape,and it lifts the canopy up too much! I pulled the tape off,and sort of thought about putting the tape on the bottom
side of the canopy...but it still lifts it up too much...hmmmm....another issue to ponder!

I guess I could just use some white tape & tape it on...it'd be waterproof,look OK...but it wouldn't be very accessible!
Hmmm...hmmm...hmmm....the challenges of assembling an ARF!


Kurt