RCU Forums - View Single Post - Vectorflight Edge 540 build
View Single Post
Old 11-04-2005 | 09:41 PM
  #1381  
BunnMan
Member
 
Joined: Jun 2005
Posts: 55
Likes: 0
Received 0 Likes on 0 Posts
From: , MD
Default RE: Vectorflight Edge 540 build

gjeffers,

OK, you got me...you used terms I don't know yet . I'd love to answer your question but don't know what or where the spraybar is so if you could educate me a little? I've been out of the hobby for 12 years or better and don't recal that one. If you mean the tank centerline and carb/needle is fairly well dead on as best I can tell.


Hehehhe, ready to maiden this bird tomorrow! Got everything checked and double checked except for getting the engine running right. Ran out of daylight before I got done tweakin' it. Had to add 5/8oz. lead to the left wingtip to balance laterally and 2 7/8oz. to the tail to balance at 4" with a half tank of juice. I'd love to get a total weight but can't figure how to weigh it. Give y'all a report tomorrow night I hope.

God bless,

-BunnMan