RCU Forums - View Single Post - 12mm to 14mm hex wheel adapter DrHonda?
Thread: 12mm to 14mm hex wheel adapter DrHonda?
View Single Post
Old 11-08-2005 | 09:45 PM
  #15  
alvinl's Avatar
alvinl
Senior Member
 
Joined: Jul 2005
Posts: 2,131
Likes: 0
Received 1 Like on 1 Post
From: ,, MO
Default RE: 12mm to 14mm hex wheel adapter DrHonda?
ORIGINAL: rolland

I have a 2 of the Renegade adapters that I am not using and have no use for. I am not sure what happened to the other 2, I haven't seen them since I moved.
If somebody wants them all they have to do is pay for the postage.

alvinl, that ATX roller went for 29.87. I can't believe I was out did by 2 cents.


rolland
I bet you were outbid in the last couple minutes. I almost bid on that. I have been thinking about getting a cheap rolling chassis to start a project car. This stuff is addictive.
alvinl is offline  
Reply Like