ALL,

I am an avid Heli Pilot with a very good knowledge base in this area, however I want a plane to have something different.

I have flown a friends plane a couple of times and found it rather relaxing compared to the concentration level required from rotary wing!

So with this in mind I acquired at rock bottom price a 72" ARF EDGE 540 kit NIB

The kit has foam cored wings and tailplane (apart from the fin).

Motor recommendations are 1.08 to 1.60 cu in the model requires two Aileron and 2 Elevator servos and 1 rudder and obviously a throttle.

I have been thinking of the following set up please feel free to comment

OS 1.60FX
1x HS 425bb
4x HS525bb/mg
1x HS635bb/mg
1x JR700 Rx
12x8' prop
Spinner
Pitts style muffler
HD switch harness

Please if i have missed anything let me know or i am off the mark

ALso bear in mind although I will fly the model on low rates etc I want the model to be very onsellable and setup with the right gear for the model.

If there is anywhere i could save on the cost of the setup please let me know also.

Thanks