RCU Forums - View Single Post - prop diameter vs pitch
View Single Post
Old 11-28-2005 | 12:54 AM
  #28  
multiflyer
Senior Member
 
Joined: Oct 2005
Posts: 254
Likes: 0
Received 0 Likes on 0 Posts
From: simi valley, CA
Default RE: prop diameter vs pitch

Regarding my general comments above.

Dr.1 points out “Most is not all” and my comments are “true in generalization only.” That’s very correct. My comments were aimed at the “beginner” for whom this forum is dedicated. They give a basic feel for it all, especially for the traditional middle of the road stuff they are likely to be involved with in their early stages of pursuing this hobby.

I was just commenting on another thread about the very large range in performance that today’s modelers are asking for, and getting, from manufacturers. No doubt the future will only bring more diversity.

Multiflyer