RCU Forums - View Single Post - micro servo
Thread
:
micro servo
View Single Post
11-12-2002, 11:51 AM
#
2
Vince
Senior Member
My Feedback: (
1
)
Join Date: Feb 2002
Location: Nederland, Tx.
Posts: 1,642
Likes: 0
Received 1 Like on
1 Post
micro servo
While it will probably work fine, one needs to insure that the linkage is very smooth with this low power servo. 32oz torque is not very much. Personally I would go with something a little more beefy.
Vince
Reply
Like
Vince
View Public Profile
Send a private message to Vince
Find More Posts by Vince
View iTrader Profile