RCU Forums - View Single Post - What surface do you put the strongest servo on when talking about 3D planes and 3D flying
Thread: What surface do you put the strongest servo on when talking about 3D planes and 3D flying
View Single Post
Old 12-21-2005 | 07:31 PM
  #6  
rmenke
Senior Member
My Feedback: (13)
 
Joined: Jun 2004
Posts: 2,118
Likes: 0
Received 0 Likes on 0 Posts
From: Merced, Ca., CA
Default RE: What surface do you put the strongest servo on when talking about 3D planes and 3D flying
Onaedge:

You are right on. If your airplane will not move from a horizontal knife edge and then pull up into a hover you are either underpowered at the elevator or not flying a rcx planes .com. Now thats rudder authority. Oh yea, my Cap X wil also do that with a Jr 8611 on the rudder.
rmenke is offline  
Reply Like