RCU Forums - View Single Post - trailing edge.. to round off, or not to round off??
Thread: trailing edge.. to round off, or not to round off??
View Single Post
Old 11-23-2002 | 08:13 AM
  #13  
Merlin65
 
Joined: Feb 2002
Posts: 227
Likes: 0
Received 0 Likes on 0 Posts
From: MelbourneVictoria, AUSTRALIA
Default trailing edge.. to round off, or not to round off??
A popular method is to laminate a piece of 1/64 ply in between 2 pieces of balsa. This allows a very fine edge that is also resistant to hangar rash. Others have achieved the same thing by impregnating the trailing edge with cyano.
There is a weight penalty however.
Any other variations?
--
Merlin
Merlin65 is offline  
Reply Like