ORIGINAL: EASYTIGER
Before you start cutting, make sure you and Todd are talking about the same tailcone. I have an early single-piece tailcone that has a MUCH smaller opening than my later one piece tailcone, and I don't know if Todd has seen the later one, or if that's what you have. Obviously, there is a problem that is NOT involving the tailcone!
Thanks for the heads up. I just ordered my single piece from Joe a month ago. Can you measure the diameter of yours? I just measured mine at 45.5 mm.
Todd, any chance of me getting a measurement from your friend who opened theirs up?
Mike