RCU Forums - View Single Post - Aileron to Servo Setup
Thread: Aileron to Servo Setup
View Single Post
Old 02-23-2006 | 03:30 PM
  #1  
KW_Counter
Senior Member
 
Joined: Feb 2003
Posts: 1,555
Likes: 0
Received 0 Likes on 0 Posts
From: Lake County, CA
Default Aileron to Servo Setup
I read an article that when setting up the Aileron servo that the control rod should NOT be 90 degrees to the servo arm when in the neutral position.
I remember the logic seemed sound but I can't remember how to calculate the angle that it should be at.
Does anyone use this theory?
How do you calculate the angle?
Thanks,
KW_Counter
KW_Counter is offline  
Reply Like