RCU Forums - View Single Post - Pull Pull Geometry problem
Thread: Pull Pull Geometry problem
View Single Post
Old 03-02-2006 | 12:21 AM
  #6  
Tricktrack
Senior Member
My Feedback: (2)
 
Joined: Nov 2003
Posts: 261
Likes: 0
Received 0 Likes on 0 Posts
From: Columbus, NE
Default RE: Pull Pull Geometry problem
My servo arm does have offset in it as suggested in the Manual by QQ. That is what confused me too as the control horns look to be on or almost on the hinge line. Are you thinking that a straight arm?
Tricktrack is offline  
Reply Like