Spade type Connector
11-15-2005 | 11:33 PM
#1
Thread Starter
Joined: Oct 2005
Posts: 396
Likes: 0
Received 0 Likes
on
0 Posts
From: ACTAustralia, AUSTRALIA
Spade type Connector
Im running some small about 3mm width brass spade connectors on my ship
I have got some 2.4 mm round gold plated connectors
Will it really make any difference if I put them on
Im pulling 11 Amps
Thanks
11-16-2005 | 06:51 PM
#2
Thread Starter
Joined: Oct 2005
Posts: 396
Likes: 0
Received 0 Likes
on
0 Posts
From: ACTAustralia, AUSTRALIA
RE: Spade type Connector
I think I can answer my own question pretty well
My wife didnt have a clue and she's an Electrical Engineer
Brass seems fine,,,,,,,,,, it hovers easily at 3/4 throttle which is where a 2 cell, 12.4 ounze AUW, 350 brush , 6,66 to 1 with a 12 by 6 prop ship, should do
Ive got those fancy 2.4 gold connectors but am just too lazy to put em on, if its sort of going to waste my time
Ive got another wing that will save about 1 ounze and replace the 15 gram servo on aileron with a 6 gram one and happy days are here again
My wife didnt have a clue and she's an Electrical Engineer
Brass seems fine,,,,,,,,,, it hovers easily at 3/4 throttle which is where a 2 cell, 12.4 ounze AUW, 350 brush , 6,66 to 1 with a 12 by 6 prop ship, should do
Ive got those fancy 2.4 gold connectors but am just too lazy to put em on, if its sort of going to waste my time
Ive got another wing that will save about 1 ounze and replace the 15 gram servo on aileron with a 6 gram one and happy days are here again
