e-flite mini funtana
07-22-2008 | 02:46 PM
#1
Thread Starter
Junior Member
Joined: Jul 2008
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
From: San Jose, CA
e-flite mini funtana
I acquired a funtana mini, after getting it home noticed the wings where only held in place by the small hex headed bolt on the inside. Does anybody know if the wing spar(tube) that fits inside of the wing and fuselage tube is a wooden dowl or what kind of material?
Thanks for any help.
Thanks for any help.
07-22-2008 | 08:40 PM
#2
Senior Member
My Feedback: (13)
Joined: Jun 2004
Posts: 2,118
Likes: 0
Received 0 Likes
on
0 Posts
From: Merced, Ca.,
CA
RE: e-flite mini funtana
don77
The original mini funtanna had a carbon tub spar through the fuse into each wing half in the usual manner. Flew so well, I gave it away, so did the second owner and on and on. Soulds like you got a 20th hand me down or so. There must be someone out there that liked the thing, never met one though. It will fly streight and land OK, beyond that your asking for a low or high speed snap. ENJOY
The original mini funtanna had a carbon tub spar through the fuse into each wing half in the usual manner. Flew so well, I gave it away, so did the second owner and on and on. Soulds like you got a 20th hand me down or so. There must be someone out there that liked the thing, never met one though. It will fly streight and land OK, beyond that your asking for a low or high speed snap. ENJOY
