Is this linkage strong enough??
08-20-2003 | 04:32 AM
#1
Thread Starter
Member
My Feedback: (12)
Joined: Feb 2002
Posts: 76
Likes: 0
Received 0 Likes
on
0 Posts
From: Lubbock, TX
Is this linkage strong enough??
I am building a 34% Edge. I have some Nelson linkage that I have never used before and would like some feed back.
I have used the type that connects to the control horn with nut and bolt but this type just pops over two small round pivot points.
You spread out the clevis and it snaps into place.
It looks like this could snap off just as easy!!
Any thoughts?? Anyone used them and what do you think?
Thanks
Eldon
Texas
I have used the type that connects to the control horn with nut and bolt but this type just pops over two small round pivot points.
You spread out the clevis and it snaps into place.
It looks like this could snap off just as easy!!
Any thoughts?? Anyone used them and what do you think?
Thanks
Eldon
Texas
