3D Engine for 40 size SIG Blue Hawk Ultimate funfly
10-21-2003 | 10:00 AM
#1
Thread Starter
Member
Joined: Sep 2002
Posts: 74
Likes: 0
Received 0 Likes
on
0 Posts
From: Bloemfontein, SOUTH AFRICA
3D Engine for 40 size SIG Blue Hawk Ultimate funfly
What engine do you suggest. I have a .41 Webra speed on this plane that is nice for general flying, but not for 3D(it will not hold a torque roll etc.).
I am thinking of a Rossi R45 or R53.
Thanks for your help.
Francois
I am thinking of a Rossi R45 or R53.
Thanks for your help.
Francois
10-21-2003 | 10:21 AM
#2
Senior Member
My Feedback: (3)
Joined: Jul 2003
Posts: 1,549
Likes: 0
Received 0 Likes
on
0 Posts
From: Columbus,
GA
RE: 3D Engine for 40 size SIG Blue Hawk Ultimate funfly
Im not sure if any engine will help. I have flown two of them and while they are good sport fliers and you might get a torque roll out of them they stink at all the other 3D stuff. I would run a saito .72 or a Y.S. .63. If you go with the Rossi go with the R53. If I were you I would get myself an OMP Edge540 and be done with it 
