Here is a video of my Flip 3D, OS 50SX powered, http://www.3drc.info/media/andyflip.wmv

Hope you like it

Andy
www.3drc.info

Not bad......

would like to see some other 3d stuff but it looks like your getting the hang of tourqe rolling


Nice vid

David

Andy
I have made a 3D model which is 2.5 Kgs (5.5 lbs) and using OS 50 SX. But it is not able to pull the model out of hover. Even hovering is very difficult!! Using 5% nitro fuel and have tried 13 x 4 and 12 x 6 props. No tunedpipe.

Any suggestions??

Thanks
Vikas

Vikas,

Try 12.25 x 3.75 APC, those that you have been using are too fast and do not have that much pulling power
that you need ffor hover and vertical power.

I use an APC 12.25x3.75" i think thats right! But if you notice i also have a tuned pipe on it, running on 5% synth. Pulls out of a hover very easily.

Andy

But the revs and noise[:@]