CofG For World Models Cap232 57"
06-01-2004 | 01:42 AM
#1
Thread Starter
Senior Member
Joined: Sep 2003
Posts: 802
Likes: 0
Received 0 Likes
on
0 Posts
From: Newcastle, AUSTRALIA
CofG For World Models Cap232 57"
Does anyone know where the best place for a 3D CofG on the world models cap232 57 inch span? At the moment it is about 4 1/2 inches from the leading edge. I think it is to far to the rear as it climbs as you roll inverted, and when you pull the power back the tail sags! Does wild blenders even on low rates though!!!!
