This thread has run it's course and is now locked. Thanks everyone for trying to help this member out

Blue_moon_, just setup your plane like it was intended.


Woops

Hmm.. i cant do that according to many writers in this thread. the plane will crash!

Bubbagates, I'm sorry, I must have missed your post about locking this thread. Please delete my post after your post.


Sincerely,
Woops

At the request of the original poster I have unlocked this thread. Anymore petty bickering will get it deleted.

Blue_moon,

No one said it will crash. Please re-read the thread

Now as far as 3D is concerned, your choice of servos will not be enough for all out 3D.

Actually come to think of it, for the quoted 72" wingspan you are most likely looking at a 120 sized airplane so I'm suspecting that even the 225's will be marginal for normal flying on the rudder and elevators

Do you have a weight on the plane with everything but the servos installed???

Since the manual is not available, knowing the weight would be a big help in choosing servos

To give you a good idea, I fly a Hangar 9 showtime with an all up weight of 9lbs not including fuel. Here are the recommended 3D servos stright from the Showtime's manual with their weights and torque specs to give you an idea and this plane is SMALLER and LIGHTER than yours

JR9411 Ultra Precision Wide Bearing (aileron and elevator)
Torque: 82 oz/in Speed: .15 sec/60°
Weight: 1.36 oz Size: 0.75” x 1.41” x 1.03”
Motor: Coreless Ball Bearing: Dual widespaced
JR8411SA Digital Ultra Torque (rudder)
Torque: 155 oz/in Speed: .18 sec/60°
Weight: 2.00 oz Size: 0.75” x 1.54” x 1.36”
Motor: Coreless Ball Bearing: Dual widespaced

So see you want facts, but we need you to provide more facts and have asked for them many times now. It appears you are looking for someone to say your choices are fine when they are not

Woops,

No sweat...I spoke privately with Blue_Moon and I agreed to repopen the thread. He just needs to listen a little better. Hopefully my last post will convince him that the servos he is asking about will be borderline for normal everyday flying and not even close enough for 3D flying.

Then im going for choice no. 4

Thanks everyone!