Quest 3D for Pattern
04-16-2006 | 07:41 PM
#1
Thread Starter
Junior Member
Joined: Feb 2006
Posts: 27
Likes: 0
Received 0 Likes
on
0 Posts
From: Effingham,
SC
Quest 3D for Pattern
I am thinking of getting into pattern flying again, and saw this airplane on Ebay. What do you guys think of the Quest by Ultra R/C? Is it a good .90 sized pattern plane?
Thanks.
[link=http://cgi.ebay.com/Ultra-R-C-3D-Quest-ARF-NIB_W0QQitemZ6051675939QQcategoryZ19164QQssPageNam eZWDVWQQrdZ1QQcmdZViewItem]http://cgi.ebay.com/Ultra-R-C-3D-Quest-ARF-NIB_W0QQitemZ6051675939QQcategoryZ19164QQssPageNam eZWDVWQQrdZ1QQcmdZViewItem[/link]
Thanks.
[link=http://cgi.ebay.com/Ultra-R-C-3D-Quest-ARF-NIB_W0QQitemZ6051675939QQcategoryZ19164QQssPageNam eZWDVWQQrdZ1QQcmdZViewItem]http://cgi.ebay.com/Ultra-R-C-3D-Quest-ARF-NIB_W0QQitemZ6051675939QQcategoryZ19164QQssPageNam eZWDVWQQrdZ1QQcmdZViewItem[/link]
04-16-2006 | 09:36 PM
#2
Joined: Sep 2003
Posts: 1,413
Likes: 0
Received 0 Likes
on
0 Posts
From: HENDERSON,
NV
RE: Quest 3D for Pattern
There's a lot of info in the "Pattern" thread on the old and the new Quests.
Regards,
Eric.
[link=http://www.rcuniverse.com/forum/m_2502127/tm.htm]http://www.rcuniverse.com/forum/m_2502127/tm.htm[/link]
Regards,
Eric.
[link=http://www.rcuniverse.com/forum/m_2502127/tm.htm]http://www.rcuniverse.com/forum/m_2502127/tm.htm[/link]
