the ultamate 3D setup?
04-26-2006 | 05:54 PM
#1
Thread Starter
Member
Joined: Apr 2006
Posts: 70
Likes: 0
Received 0 Likes
on
0 Posts
From: gilbert, AZ
the ultamate 3D setup?
hey guys. I am looking for a new 3D aircraft. anything over a .60 size plane. what would be the best setup. with no regard to price. thanks
04-26-2006 | 09:09 PM
#2
Senior Member
My Feedback: (1)
Joined: Jul 2004
Posts: 1,834
Likes: 0
Received 0 Likes
on
0 Posts
From: Lynchburg,
VA
RE: the ultamate 3D setup?
no reguard to price HUH ,,,,, A Carden 40% edge 3W 212 and a couple thousand more of goodies with an enclosed trailer and a 14 MZ ,2 honda generators, an RV and a map to all the fly-ins all over the country. hope this helps
04-26-2006 | 09:38 PM
#3
Senior Member
Joined: Mar 2005
Posts: 295
Likes: 0
Received 0 Likes
on
0 Posts
From: Venus BayVictoria, AUSTRALIA
RE: the ultamate 3D setup?
ha ha i have that... now i want the GOOD setup. bill hempel 52% edge baby!
seriously though if you want 60 size i'd go that new fliton edge with saito 100 - 125 depding on your flying style
seriously though if you want 60 size i'd go that new fliton edge with saito 100 - 125 depding on your flying style
04-27-2006 | 12:18 AM
#4
Junior Member
My Feedback: (5)
Joined: Nov 2004
Posts: 23
Likes: 0
Received 0 Likes
on
0 Posts
From: Murrieta,
CA
RE: the ultamate 3D setup?
Amen to that!! 52% Edge is ALL I need!
I would seriously take a look at the Wild Hare Baby Edge, or the Quique Somenzini 73" Yak, either one with a ZDZ 40, hitec 5625's
and Lithiums for power, on something that size, I wouldn't recommend dual rx batts, due to the fact that every ounce really counts!
one servo per surface should be more than enough power, plus those are very fast, and responsive. That would be my best choice for 3d before going Giant Scale. If going Giant Scale, then that's a whole other story! Good Luck!!
I would seriously take a look at the Wild Hare Baby Edge, or the Quique Somenzini 73" Yak, either one with a ZDZ 40, hitec 5625's
and Lithiums for power, on something that size, I wouldn't recommend dual rx batts, due to the fact that every ounce really counts!
one servo per surface should be more than enough power, plus those are very fast, and responsive. That would be my best choice for 3d before going Giant Scale. If going Giant Scale, then that's a whole other story! Good Luck!!
