Go Back  RCU Forums > RC Airplanes > 3D Flying!
stik input >

stik input

Community
Search
Notices
3D Flying! Our 3D flying forum is the ultimate resource for 3D flyers. Also discuss the latest in "4D" flying!

stik input

Thread Tools
 
Search this Thread
 
Old 01-23-2003 | 04:37 AM
  #1  
Thread Starter
My Feedback: (1)
 
Joined: Jan 2003
Posts: 235
Likes: 0
Received 0 Likes on 0 Posts
From: N.P., BAHAMAS
Default stik input

Whats then stick input to hoover and inverted flat spins,because im trying on RF GT and im still having difficulties.Knife edge and inverted flight no prob.
Old 01-24-2003 | 12:33 AM
  #2  
Senior Member
 
Joined: Jan 2003
Posts: 810
Likes: 0
Received 0 Likes on 0 Posts
From:
Default stik input

"Whats then stick input to hoover"

That is like asking for the control inputs to drive your car on the highway...

Basically you pull the airplane straight vertical and do whatever it takes to hold it there. Use your elevator and rudder and forget about the ailerons... If you do a little search around here, you will find hundreds and probably thousands of threads/posts about how to hover and tips and tricks to get better at it. It all takes practice!

As far as doing a flat spin on G2, it won't happen. Here is how to do one though-

Enter a normal spin with full left aileron and rudder, full up elevator, and half throttle. After a couple spins S L O W L Y move the aileron stick over without changing anything else and it should flatten out. Most airplanes with recommended throws will not do a very good one if they will do one at all. A true flat spin on G2 is not possible...

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Trackbacks are Off
Pingbacks are Off
Refbacks are On



Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.