4-40 linkage question
12-25-2006 | 09:15 PM
#1
Thread Starter
Senior Member
My Feedback: (21)
Joined: Jan 2004
Posts: 112
Likes: 0
Received 0 Likes
on
0 Posts
From: GAHANNA, OH
4-40 linkage question
I just replaced my v2 kat and would like to go first class on the control linkage. I'd like to go with 4-40, ball links, etc. Can anyone offer advice on a setup you've had luck with? Thanks
12-26-2006 | 09:11 AM
#4
My Feedback: (3)
RE: 4-40 linkage question
Other than the Central Hobbies carbon fiber stuff, my other favorite is the Hangar 9 Pro Link Titanium turnbuckles.
They are more expensive but they are LIGHT and allow you to make very fine adjustments without disassembling the pushrod assembly if you are using ball links. Another limiting factor is the length. But they make them up to at least 4 1/2" if not more.
http://www.horizonhobby.com/Products...ProdID=HAN3553
They are more expensive but they are LIGHT and allow you to make very fine adjustments without disassembling the pushrod assembly if you are using ball links. Another limiting factor is the length. But they make them up to at least 4 1/2" if not more.
http://www.horizonhobby.com/Products...ProdID=HAN3553
