i could have sworn i had already posted it but here it goes again...

i recently took off my trusty Saito 150 off my Lanier Edge 540 and installed on my new maxair Velox, i test ran it on the ground ealier today and i noticed it lacking power, and it had a rough idle, so with the engine off spun the prop manually and could feel an heard roughness


i checked with a place that specializes in repairing saitos and its gonna run me close to 100 bucks back to my doorstep.....

Does anyone know of a good site that goes through the process step by step in how to change bearings, perhaps even with illustrations?

Send it in, it would cost you more in your own time and if you make a mistake it is even more money down the drain, Let a Pro do it.