3DHS Extra 300 SHP problem
12-18-2009 | 06:33 PM
#1
Thread Starter
Member
My Feedback: (8)
Joined: May 2004
Posts: 68
Likes: 0
Received 0 Likes
on
0 Posts
From: Stilesville,
IN
3DHS Extra 300 SHP problem
Hello I just recieved my SHP and I have run into a problems with it during my build.
-The pushrods seem to be to big for the holes cut into the control horns. I was wondering if there is a safe way to make the holes larger to accept the Z-Bends?
-The pushrods seem to be to big for the holes cut into the control horns. I was wondering if there is a safe way to make the holes larger to accept the Z-Bends?
