how to program 9C, twin elevator servos with 6ch RX
 

Hello all
i need a bit of help i have a razzle and it has two elevator servos. how do you program the 9C withe ailevator because the default second elevator servos is ch 8. how to make it channel 5
thanksregards
james

RE: how to program 9C, twin elevator servos with 6ch RX
 

you can do this but you can not trim the elevators once you do this (basically 1 will trim while the other stays at 1 point, its a really wierd mix).
get an 8 channel like hitec supereme and you won't have any problems.

RE: how to program 9C, twin elevator servos with 6ch RX
 

www.futaba-rc.com/faq/faq-9c-q512.html

Try this channels 2and 5.

RE: how to program 9C, twin elevator servos with 6ch RX
 

That is incorrect. In the 9C, you can change the channels in the mix - which one is master, which one is slave. In the 9C, trims ARE slaved in the dual elevator mix. In the 7C, they are not.

With a 6 ch. receiver however, you will have to run the Y on the ailerons.

RE: how to program 9C, twin elevator servos with 6ch RX
 

what do you guys suggest is a reliable gas engine in tjhe 50 to 60cc category?

RE: how to program 9C, twin elevator servos with 6ch RX
 

why would i have to use y harnes for ailerons?
channel 1,6: ail
channel 2,5: elevator
channel 3 : throttle
channel 4 : rudder

...-_-
i still dont get, how do you utelize the mix what should i substitue in place of the example of 2 and 7 by futaba

thanks regards

RE: how to program 9C, twin elevator servos with 6ch RX
 

First go to
*AUX-CH in the basic(acro) menu.
Make CH5 read NULL
Then go to a program mix. (I use 3) and set it up as follows. MIX>ON MAS>ELEV SLV>GEAR LINK>OFF
TRIM>ON SW> dosnt matter just pick one POSI>NULL
Then go to the other page and make both your rates 100% Depending on your servo position the could both be + or - 100% or one of each. This should do the trick.

david

RE: how to program 9C, twin elevator servos with 6ch RX
 

YES that did itut i had to make the LINK>ON not off
thank you sooo much:D

RE: how to program 9C, twin elevator servos with 6ch RX
 

So you have a 7 channel receiver?
1
2
3
4
5
6
B

or

1
2
3
4
5
B

Battery is normally included as a channel - when you go to Futaba's website, notice an 8 channel receiver has channels 1-7 and then a B channel for battery. That's why as I said you would need a Y Harness for ailerons. If you indeed have a 7 channel receiver you're fine.