RCU Forums

RCU Forums (https://www.rcuniverse.com/forum/)
-   3D Flying! (https://www.rcuniverse.com/forum/3d-flying-82/)
-   -   Thrust ? (https://www.rcuniverse.com/forum/3d-flying-82/7809146-thrust.html)

skillet92 08-04-2008 08:33 PM

Thrust ?
 
Hey guys i have a GP 330S extra. It was designed for a fugi 43 or a comparable glow. I have installed a DL50:D! The plane flyes great and handle calm. The question that i have is when pulling into a vertical the plane as it is heading away from me veres to the left. to stop it i have to apply right rudder. I know that i need to learn to do these controls, but my question is could i need more right thrust. I am turning a 23A Vess prop.

krayzc-RCU 08-04-2008 08:41 PM

RE: Thrust ?
 
yes addd more a little at a time until u get the desired effect

MetallicaJunkie 08-04-2008 09:46 PM

RE: Thrust ?
 
sounds like its doing a high speed stall, ...... ok is it when you are are pulling back hard , or do you mean when you are doing a a gradual vertical upline?

Jake Ruddy 08-04-2008 10:02 PM

RE: Thrust ?
 
yes you need more right thrust

skillet92 08-05-2008 05:13 AM

RE: Thrust ?
 
Thanks guys i am going to start added thin washers to the left stand offs. And see if that helps any.

And MetallicaJunkie it does it weither the pull into a verticall is gradual or fast. It just goes to the left i have not checked but i am willing to bet that if i took off and turned the plane directly away from me that is doing the same the in level flight. I have had to do more than normal correcting on the aproach now that i think of it

MetallicaJunkie 08-05-2008 10:30 AM

RE: Thrust ?
 
good luck with your airplane


Jake Ruddy 08-07-2008 12:43 PM

RE: Thrust ?
 
wait a sec... you are not talking about a vertical line, just when you pull on the elevator?

Sounds like your elevators are out of sync and not travelling at the same time. Put 2 bamoo sticks on the elevators so they meet behind the rudder.. then see if the sticks stay together when you give it up elevator.


All times are GMT -8. The time now is 03:51 AM.


Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.