Thrust ?
#1
Thread Starter

Joined: Feb 2006
Posts: 1,133
Likes: 0
Received 0 Likes
on
0 Posts
From: camden, SC
Hey guys i have a GP 330S extra. It was designed for a fugi 43 or a comparable glow. I have installed a DL50
! The plane flyes great and handle calm. The question that i have is when pulling into a vertical the plane as it is heading away from me veres to the left. to stop it i have to apply right rudder. I know that i need to learn to do these controls, but my question is could i need more right thrust. I am turning a 23A Vess prop.
! The plane flyes great and handle calm. The question that i have is when pulling into a vertical the plane as it is heading away from me veres to the left. to stop it i have to apply right rudder. I know that i need to learn to do these controls, but my question is could i need more right thrust. I am turning a 23A Vess prop.
#5
Thread Starter

Joined: Feb 2006
Posts: 1,133
Likes: 0
Received 0 Likes
on
0 Posts
From: camden, SC
Thanks guys i am going to start added thin washers to the left stand offs. And see if that helps any.
And MetallicaJunkie it does it weither the pull into a verticall is gradual or fast. It just goes to the left i have not checked but i am willing to bet that if i took off and turned the plane directly away from me that is doing the same the in level flight. I have had to do more than normal correcting on the aproach now that i think of it
And MetallicaJunkie it does it weither the pull into a verticall is gradual or fast. It just goes to the left i have not checked but i am willing to bet that if i took off and turned the plane directly away from me that is doing the same the in level flight. I have had to do more than normal correcting on the aproach now that i think of it
#7
Senior Member
My Feedback: (40)
wait a sec... you are not talking about a vertical line, just when you pull on the elevator?
Sounds like your elevators are out of sync and not travelling at the same time. Put 2 bamoo sticks on the elevators so they meet behind the rudder.. then see if the sticks stay together when you give it up elevator.
Sounds like your elevators are out of sync and not travelling at the same time. Put 2 bamoo sticks on the elevators so they meet behind the rudder.. then see if the sticks stay together when you give it up elevator.




