Green Model Spirit 3d Arf
There is not too much press about this model. However I picked one up from the local hobby shop Friday afternoon and I am very impressed with the quality. The model is all built up out of laser cut balsa. It is covered with lightweight translucent covering (not sure on the brand but good quality and light) It has plug in style wings with a carbon fiber wing tube. All of the controll surfaces are prehinged with the covering wich is a very nivce feature. The push rods are all prebent with z bends on both and the fit of them was perfect. This model took me less than an hour of total time (actually a little over 30 minutes)to put togather the The fit on all the parts were perfect so I was able to use ca to asseble the tail group. For power I have an e-flight 400 outrunner and an apc 11-3-8 prop. Test flight should be this week sometime. I will post a flight report then.