RCU Forums - View Single Post - Setting the high speed needle.
Thread: Setting the high speed needle.
View Single Post
Old 03-16-2006 | 08:53 PM
  #4  
Dr1Driver
Senior Member
 
Joined: Jul 2002
Posts: 3,770
Likes: 0
Received 2 Likes on 2 Posts
From: Spartanburg, SC
Default RE: Setting the high speed needle.
If you're talking about glow engines, use the pinch test. At full throttle, briefly pinch the fuel line. if the engine sags immediately, it's too lean. If it speeds up a little but keeps running, it's just about right.

Dr.1
Dr1Driver is offline  
Reply Like