i have a .11 kyosho on my nitro blizzard, havent ran the engine in a little while, it runs but wont seem to keep drawing fule out the fule tank, every time i prime it, it runs for a few secs then dies, ive changed all my fule lines, i made sure my tank was sealed and freeflowing. checked my glowplug and glowplug looks great, after a few tries the engine has no trouble starting at all, drawing fule is its only problem. i pulled out the high speed needle, blew it off and blew down the hole trying to clear any obstuction, fule has no trouble drawing up to the carb when putting a finger over the exaust and priming. im kinda running out of ideas, other than tearing apart my carb at this point, any OTHER ideas? im kinda lost.