I have an LT-40 that I have just recently fitted with a pair of floats and I thought that I was Ready To Float but then I discovered a problem with my water rudder. When I move the rudder stick right or left, it centers in a different position from when I push the stick right than it does when I push left. Has this ever happened to any of you? Is a hitec standard servo enough to push both rudders? I am including some pictures below, the one on the far left is a picture of where the rudder centers when I push right, and the one next to it is where it centers when I push left. I also have a few pictures of my setup.

Thanks again,

LT-40