RCU Forums - View Single Post - Official HPI MT2 Thread
View Single Post
Old 04-11-2006 | 10:43 AM
  #5786  
redfox03
Senior Member
 
Joined: Nov 2005
Posts: 1,245
Likes: 0
Received 0 Likes on 0 Posts
From: Milwaukee, WI
Default RE: Official HPI MT2 Thread

yeah i got the manual and i studied it like i was taking a quiz the next day. i see how to take it out, just wanted to make sure so i asked on here too. i got the HD diffs already in my totebag, so whenever i stop being lazy i'll put those in. i might check them out today after i run my truck through this golf course up the street from my house. always wanted to take it through the golf course, it's a course that rarely gets used, so no flying golf balls to worry about. i got te 2 speed tranny for it yesterday, but didnt install it yet because i knew i was gonna drive off road today, it's 65 degrees here finally!! i ran it yesterday, but i lost two engine mount screws in the bottom of the truck. painted my hummer body last night, and i also have my ford 250 body which i painted last thursday. two new bodies. gotta keep it looking good since it's hot outside now. the stock body is almost dead now. i'd say one more hard hit on the back,or something grabs that big spoiler i put on there, and the rear will be gone. well it's almost time for my 11 o clock class.