RCU Forums - View Single Post - first real attempt at 3d
View Single Post
Old 04-22-2006 | 04:00 PM
  #7  
skater_719
Senior Member
My Feedback: (4)
 
Joined: Oct 2003
Posts: 518
Likes: 0
Received 0 Likes on 0 Posts
From: Burlington, WI
Default RE: first real attempt at 3d

well, i found the problem. their was a small pin-hole in the fuel tank letting out pressure and i replaced the glow plug. now it runs great! now if only the wind would die down, its only about 15mph but since i fly in a field surrounded my woods thier is a lot of turbulance on landing. i also added a few degrees of right thrust so maybe that will make it a little easier.