I have cut the foam for the fuselage and the engine nacelles on my 1/12th scale B1-B. Am working on the swing-wing mechinism and carry through support. I have several hundred close up photos of the B1-B while I was stationed at Mather AFB, CA in 1988 to 1993. It has taken me a few years to get this far.
I used the 2D side of Design CAD 3000 to make all the templates for the fuse. Then I used the 3D side of Design CAD 3000 to make sure all my templates fit together. I now have a complete set of 2D and 3D images on the computer that I have translated to foam.

Roy