RCU Forums - View Single Post - Flap programming the JR 8103
Thread: Flap programming the JR 8103
View Single Post
Old 05-24-2006 | 10:37 AM
  #4  
basimpsn
My Feedback: (5)
 
Joined: Dec 2001
Posts: 2,580
Received 4 Likes on 4 Posts
From: Mia, FL
Default RE: Flap programming the JR 8103
Thats also done in the Mix program. In the mix program select flap as the master and the elev as slave. then below use the mix values to set your ELEV percentage while moving the flaps up and down.
basimpsn is offline  
Reply Like