RCU Forums - View Single Post - Mk dual elevator coupler on G-trick?
Thread: Mk dual elevator coupler on G-trick?
View Single Post
Old 12-26-2002 | 03:45 PM
  #4  
TOYMAKER
My Feedback: (6)
 
Joined: Jan 2002
Posts: 821
Likes: 0
Received 0 Likes on 0 Posts
From: Plano, TX
Default Bearings vs ball lnks
Originally posted by PatternFlyer
I
I also recommend ball bearing linkages on all the connections points to make the elevator most precise. I tried ball links on bellcrank output arms, but no good.
Use carbon fiber pushrod from servo to bellcrank, bellcrank to elevators.

Good luck.
What kinda of problems did you experience with ball links?
TOYMAKER is offline  
Reply Like