I realize tramsay that you say it is not 3D capable, but I was wondering if you could take the existing rudder and elevator and make it into a 3D machine. Did you have the throws maxed out when trying 3Ding?? I have been flying my AirCore Colt 40 and with my new Tower .75 I can actually hover it at about 100 feet for 15-20 seconds then I stall it because I don't have enough throws in the rudder and elevator. I figure that when I get my Extra I will just play with it for a little and see how far I can push it into 3Ding as far as hovering is concerned. I practice a lot on G3 using a Nextar and seeing how close to hovering I can get. I want to know....Is it POSSIBLE??