RCU Forums - View Single Post - BME 50 Wildhare Ultimate Build Thread
Thread: BME 50 Wildhare Ultimate Build Thread
View Single Post
Old 06-04-2006 | 11:59 PM
  #66  
ben beyer's Avatar
ben beyer
My Feedback: (23)
 
Joined: Nov 2002
Posts: 2,385
Received 0 Likes on 0 Posts
From: Bryan TX
Default RE: BME 50 Wildhare Ultimate Build Thread

ORIGINAL: tomriddle

Ben,

Sharp spotting. Yah...lesson learned...on the Airwild site there is a dialog regarding HiTec servos that don't have a 'cross' on the servo output shaft; for those, Airwild recommends the gold arms. My HiTecs didn't have the cross but the gold arms are definitely not the right choice - the splines are too wide. I tried one of the red arms that I had on hand - perfect fit. New (red) arms are on order. I'm smarter (again).

tom
I tried one of the red arms on one an old 5945 that I have, but it wouldn't work. Futaba arms slips right on with a little force though.
ben beyer is offline  
Reply Like