RCU Forums - View Single Post - Useing Heat and Windex to apply monokote graphics
Thread: Useing Heat and Windex to apply monokote graphics
View Single Post
Old 06-07-2006 | 01:15 AM
  #51  
somegeek's Avatar
somegeek
Senior Member
My Feedback: (2)
 
Joined: Jul 2005
Posts: 2,138
Likes: 0
Received 0 Likes on 0 Posts
From: Vancouver, WA
Default RE: Useing Heat and Windex to apply monokote graphics
Hey TERMAGATOR - thanks again for posting your method for this.

Picked up a trim sheet of black Monocote and got some letters cut out for my LT-40 - put in place with windex. Will run an iron over them tomorrow. Nothing fancy but pretty cool to see the end result.







Looking forward to doin something for my SSE I'm building... just need to figure something out! Anyway - one more tool for the toolbox.

somegeek
somegeek is offline  
Reply Like