RCU Forums - View Single Post - RCV Engines
Thread: RCV Engines
View Single Post
Old 06-12-2006 | 08:30 PM
  #83  
p61widowrc
My Feedback: (1)
 
Joined: May 2005
Posts: 48
Likes: 0
Received 0 Likes on 0 Posts
From: Kewanee, IL
Default RE: RCV Engines

Hey thekosz,
I just ran my 91-sp for the second or so time. The first two times was just to start it and test out my starting procedure. This time I ran it for a little over 15 minutes and I am amazed at the amount of fuel it ran on. I totally agree with you on how little fuel it runs on. I don't get alot of slobber or oily mess on the engine. I was doing a double take the whole time trying to see the fuel go down on my test tank. I sure hope this engine proves out. I'm putting together a VQ P 61 using two of these babies and right now I am impressed. I used an electric drill with the hex driver just to turn it over a few rpm just to loosen the engine up. After that I put the glow to her and started it by hand flipping the prop. I really am looking foward to getting this engine in the air, but I've got a long way to go.
Take care everyone,
Bob