RCU Forums - View Single Post - Mvvs 1.60 Engine priming problem
View Single Post
Old 06-20-2006 | 10:17 PM
  #7  
rcplaincrazy
Member
 
Joined: Mar 2003
Posts: 81
Likes: 0
Received 0 Likes on 0 Posts
From: Toughkenamon, PA
Default RE: Mvvs 1.60 Engine priming problem

LOL Dick what a hoot yeah but but but these are "PURPOSE BUIL RC ENGINES" JUST FOR AIRPLANES???? the choke arm on the mvvs is a fine example I spent 2 hours rigging that up to work from a servo. and the set up is marginal at best. Unfortunateley not everyone in this sport / hobby Namely me, has the time or knowledge to figure this crap out. I mean like I need pictures nstrucktchuns.
Thanks Pe. for the help the engine runs great its just a little hard to start the first time. I bought a small syringe at the drugstore to squirt a litle fuel in the carb just enough for a short burst that seemed to pull The fuel in and the engine started with only five flips. will priming the carb this way damage the engine. the engine is mounted inverted on an ultra rc giles and the carb is right out in the air after a few flights I noticed fuel spray on the cylinder and header I am wondering what the chance of a fire on board is with the unburnt fuel on the header.
thanks again guys