I have been flying it a little and started to set it up for 3d when I ran into a problem. My radio is a futaba 8uaps. I have the elevators on channel 7 and 8 mixed to channel 2. I did this because when only one was on 7 and the other was on 2 the 7 half was faster than the 2 half. So now they are on 7 & 8 and I can not get them to match up perfectly. They are very very close just not perfect. They other issue that complicates is that the control arm of one servo points up and the other down. I assume it is just the geometry of the situation.

I will be flying it this weekend and I feel that there will not be any huge issues, but I just wondered how every body else does it.

Thanks
Scott