I got about 2hrs. total on it with 30min of that in the air. I got a question, the very first time I touched the low end needle on the .91cd, I was turning it in to see where it was set at. After about 2 or 3 turns in it just wasn't there anymore, the needle literally fell into the barrel of the carb. Now i've tuned ALOT of motors in my time, but this was new to me. Now the needle had never been touched until this point, factory setting. Ran so good I just never messed with it, was slightly rich. I actually havn't run it since, I took it off the plane until I figure this out.

Shane