thanks alot guys

from what ive read here shes good to go.
ive done at minimal everything the instructions say. (wasted alot of epoxy but its written there for a reason)

i however have also made a few mods. for one my engine area is epoxeyed and so is my fuel tank area, im also looking for away to seal it off from the servo area and ideas are welcomed.
i use locktite on the set screws on the wheel collers after tightening them and triple checking it.
so i guess i take either the butterfly or the bob martin ET out to the club come march/april and see what happens.

the arf would make crashing alot easier sence ive put many hours into these birds but i built them to fly so fly she will do.