RCU Forums - View Single Post - How do you remove the main shaft in a BCP?
Thread: How do you remove the main shaft in a BCP?
View Single Post
Old 07-07-2006 | 12:54 PM
  #4  
Gonwee
Senior Member
 
Joined: Jun 2006
Posts: 171
Likes: 0
Received 0 Likes on 0 Posts
From: Grass Valley, CA
Default RE: How do you remove the main shaft in a BCP?
Might be a good idea to try not to get any on the swash plate, might get in the bearing. But some compressed air should take care of any grains that get on it.
Gonwee is offline  
Reply Like